Table of Contents
Advertisement
Terminals VMT5017
8 S
OFTWARE
The device will be delivered with a pre-installed Windows operating system on request by
the customer. The drivers required for this are already installed, and the operating system
will be enabled by entering the licence information. Should an initial installation be
required, please adhere to the following steps. With a newer operating system like
Windows XP, the network card and graphics card will properly be recognised during initial
installation, so that only the touchscreen driver and the soft keyboard must be installed
separately.
Note:
If the hard drive was formatted, the operating system can be reinstalled by using one of
the existing interfaces.
An external keyboard is required for installation.
8.1 I
NSTALLING THE OPERATING SYSTEM
If the device is not equipped with an integrated drive, installing the operating system can
only be carried out by using the USB interface.
Procedure for installation:
USB:
•
•
•
•
If Windows CE.net or Windows XPe is used, the entire operating system may be
completely installed from the USB stick using the respective image. The required image
can be purchased from the ads-tec company or via the ASSIX online portal.
Pos: 36 /Datentechnik/Software / Treiber Installation/Touch Screen/Touch Screen Installation für OPC 5112/5212/5315/5515/5317/5319 / CPC5006/OTC5006/ VMT-Serie @ 0\mod_1159175108636_681.doc @ 931 @
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
&
DRIVER INSTALLATION
The boot drive in the system Bios must be switched to USB in order to boot the
device from the USB interface.
Restart the device and insert the Windows CD.
Windows installation and basic data setup
With devices using a touchscreen, the full functionality range or touchscreen
drivers and the soft keyboard should be installed.
31
Advertisement
Table of Contents
