Table of Contents
Advertisement
Terminals VMT5017
6.7 N
ETWORK CONNECTION
If the drivers required for functioning are installed on the device, the control system may
be integrated in an Ethernet network supporting the 10/100 Mbit standard by using the
Ethernet 10/100BaseT network connector. Specifications of this network topology must be
observed in this case. You can install the drivers required for functioning from the enclosed
service CD, should they not be installed on the device.
PIN NUMBER
Pos: 31 /Datentechnik/Schnittstellen/Line Out/Line Out / Sound für VMT-Serie @ 0\mod_1159172305673_681.doc @ 917 @
6.8 L
O
INE
UT
The Line Out connection of this device is a 3.5 mm socket which provides a stereo signal.
In order to use this connection, the matching plug must be wired up as follows.
PIN NUMBER
Ground
Pos: 32 /Datentechnik/Schnittstellen/Funknetzwerkkarte/Funknetzwerkkarte für VMT-Serie @ 0\mod_1159172416532_681.doc @ 919 @
6.9 O
PTIONAL RADIO NETWORK CARD
If a slot with a radio network card and an externally attached antenna is installed in the
device, and if this card is supported by the corresponding drivers in the operating system,
this device may be integrated in an Ethernet network supporting 11 Mbit or 54 Mbit
(802.11a/b/g compatible) connections. Specifications of this network topology must be
observed in this case.
Pos: 33 /Datentechnik/Laufwerke/Festplatte / Compact Flash/Festplatte Compact Flash für VMT-Serie @ 1\mod_1204714324328_681.doc @ 3409 @
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
(RJ45)
SIGNAL NAME
1
2
3
4
5
6
7
8
/ S
OUND
SIGNAL NAME
R
Signal, right-hand side
L
Signal, left-hand side
TX +
TX -
RX +
NC
NC
RX -
NC
NC
GND
29
Advertisement
Table of Contents
