Network Connection (Rj45); Erial Com Interface (Rs232) - ADS-tec IPC1300 User Manual

6.5 N
ETWORK CONNECTION
If the drivers required for functioning are installed on the device, the control system may
be integrated in an Ethernet network supporting the 10/100/1000 Mbit standard by using
the Ethernet 10/100/1000BaseT network connector. Specifications of this network topology
must be observed in this case. You can install the drivers required for functioning from the
enclosed service CD, should they not be installed on the device.
PIN NUMBER
Pos : 31 /D atentec hni k/Schnitts tell en/Seriell e Schnitts tell e C OM RS232/Serielle Sc hnitts tell e C OM (RS232) für OPC / IPC / C PC / PLC / OTC / ITC / VMT / M SA- Serie @ 1\mod_1249303286408_681.doc @ 6105 @
6.6 S COM
ERIAL
The serial interface is used for digital and for analogue data transmission as well. The RS
232 interface can be connected by using a commercially available 9-pin SUB-D cable.
PIN NUMBER
Note:
This interface is not electrically isolated.
Pos : 32 /D atentec hni k/Laufwer ke/Exter ne Laufwerke/Exter ne Laufwer ke für OPC 5112 / 5115 / 5117 / IPC 1100 / CPC / PLC / OTC / ITC / VMT-Serie @ 0\mod_1158926656205_681.doc @ 880 @
20
(RJ45)
SIGNAL NAME
1
2
3
4
5
6
7
8
(RS232)
INTERFACE
SIGNAL NAME
1
2
3
4
5
6
7
8
9
TX +
TX -
RX +
NC
NC
RX -
NC
NC
DCD
RxD
TxD
DTR
GND
DSR
RTS
CTS
RI
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
Industrial PCs IPC1300