Pro-face GP3000 Series Hardware Manual page 213

GP3000 Series Hardware Manual
9.4 Replacing the Backlight
• The GP-3200/3300/3400's backlight and AGP-3500L's backlight cannot be
9.4.1 AGP-35∗0T
• Use the following table to check that you have ordered the correct backlight.
AGP-3500T
AGP-3550T
AGP-3510T
AGP-3560T
*1 The revision number of the GP is shown in the label affixed to the GP.
CA5-BLU10T-01
Preparation
Please have the following ready beforehand.
• Replacement backlight (Model: CA5-BLU10T-01)
• One pair of clean (preferably new) cotton gloves.
• Phillips screwdriver (no.2)
About the Backlight
GP units use a CFL, long-life type backlight. In a real world situation, the backlight may need to be replaced
depending on the GP's operating environment. It is recommended that it be replaced periodically.
A backlight life refer to " Display Specifications (page 4-48)", when the backlight is lit continuously (time
required for brightness to fall to half its normal level.)
9-6
replaced by the user. When the backlight needs to be replaced, please contact
your local GP distributor.
*1
GP Rev
-
Rev.2 is
marked.
-
In the example shown below, an asterisk "*" is displayed in the position
where "2" should be, meaning "Rev. 2".
Backlight
Attachment Procedures
Model
SEE
CA5-
BLU10T-01
CA5-BLU10T-01 (page 9-6)
SEE
CA6-
BLU10T-02
CA6-BLU10T-02 (page 9-11)