Elevation | 30750 - Sears 30750 Service Manual

Treadmill Troubleshooting
>> Elevation | Model 30750 Only
1. VERIFY the Customer is using the Two Touch Confirm
2. Verify C.C. connection at the MCB and customer assembly points
Symptom
Incline is Stuck Up or Not
Functioning
The incline increases as
soon as power is applied
without pressing start.
The incline will only go up.
It is stuck either at the top
or the middle.
Possible Cause
CC is loose, unattached or
damaged.
Improper use of the Two
Touch membrane Keys.
MCB is defective.
Buttons are stuck.
CC is defective.
Test Procedure
Turn off the Unit at the
base. Wait 30 seconds
then turn unit back on.
Check CC at each
connection point.
Unplug and reattach,
making sure the
connection is secure.
Verify the CC is connected
to the MCB.
Verify the customer is
confirming each selection.
Test the Incline Buttons
Verify they are
functioning.
Verify The CC conections.
008 Sears CA Treadmill Service Manual [rev 1.0] |
Section Three | Troubleshooting
Repair
-Replace CC if damaged.
-Replace MCB.
-Replace CC
.