Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
NOTE: A complete electric fireplace heater should consist of two parts: the wooden mantel and the
fireplace heater each packed in a separate carton. It is not recommended to use the fireplace
heater without the wooden mantel. Unpack the fireplace heater and mantel. Remove all packing
materials.
PARTS LIST:
A) Top panel
B) Base panel
C) Side panel
D1) Left front panel
D2) Right front panel
E) Upper front panel
F) Lower front panel
G) Small front panel
T) Short KD screws
U) Mounting clips
V) Mounting brackets
W) KD screws
X) Plastic connector
WARNING: Make sure the fireplace INSERT controls are in the OFF position and the INSERT is
NOT plugged in.
CAUTION: Place a piece of cardboard or protective sheet on the floor in order to avoid scratching
the decorative surface of your mantel during assembly.
Please DO NOT fully tighten the KD screws until all panels are assembled.
Step 1: Attach all PLASTIC CONNECTORS (X) to the PANELS (C, D, &E) as shown in Figure A. (2
screws for each PLASTIC CONNECTORS.)
1
1
2
1
1
1
2
1
5
3
2
53
15
-5 -
Advertisement
Table of Contents
