Deleting All Old Messages; Remote Access; Setting The Security Code - Motorola H201 User Manual

2. Press MENU to listen to the caller through the handset earpiece, the
CALL SCREENING
handset displays
3. Press /SPEAKER to listen via the handset loudspeaker.
4. Press /MUTE to stop screening and leave the answering machine
to record the message.
5. Press /FLASH to talk to the caller and stop recording.

3.21.8 Deleting all old messages

1. Press MENU and then VOL+ or REDIAL/VOL- to select
MACHINE
.
2. Press MENU and then VOL+ or REDIAL/VOL- select
3. Press MENU to confirm.
NOTE
When answering machine is full,
ERASE SOME ANSWERER MSG
will toggle within 2 seconds with
idle to alert user to delete some answering machine messages to free up
the memory.

3.21.9 Remote access

Remote access allows you to operate your answering machine and listen
to your messages by calling your phone from another phone.
Turn the remote access on/off
1. Press MENU and then VOL+ or REDIAL/VOL- to select
MACHINE
.
2. Press MENU and then VOL+ or REDIAL/VOL- to select
ACCESS
.
3. Press MENU and then VOL+ or REDIAL/VOL- to select
4. Press MENU to confirm.
Using the phone
.
ANSWER
DEL ALL OLD MSG
will flash if there are new messages.
MEMORY FULL
ANSWER
REMOTE
ON OFF
or
To enter the remote access mode, dial your phone number from another
phone, when you hear the announcement, press TONE/* and then enter
the 4-digit remote security code (default code is 0000).
The correct sequence of the 4 security PIN digits needs to be detected
before entering remote access mode. Random digits detected prior to the
correct 4 digits sequence are ignored, and answering machine recording
continues until the complete PIN is detected. There is no system prompt to
enter the remote access code.
Press the following keys on your handset to perform the following
functions, after entering your remote access mode.
Press... To...
.
1 Repeat message
2 Play/Stop message
3 Skip forward to the next message
in
4 Toggle Answer Off/Announce Only/Announce and
Record modes
7 Listen to the Main Menu (for Full Voice prompts only)
0 Delete message

3.21.10 Setting the security code

This is used to change the remote access PIN if necessary.
1. Press MENU and then VOL+ or REDIAL/VOL- to select
MACHINE
.
2. Press MENU and then VOL+ or REDIAL/VOL- to select
CODE
.
.
3. Press MENU and enter the 4-digit security code.
4. Press MENU to save.
ANSWER
SECURITY
21