Rear Axle Differential Case And; Final Reduction Gear Cases; Changing Oil - Shibaura CM314 Operator's Manual

REAR AXLE DIFFERENTIAL CASE AND

FINAL REDUCTION GEAR CASES

Checking Oil Level: Check the oil level every
100 hours.
1. With the engine off and the tractor standing
level, check the oil level using the combined
dipstick/filler plug A. The oil is at the correct
level when it reads between the two marks
on the dipstick.
NOTE: place the dipstick/filler plug A
horizontally over the oil inlet and measure
the oil level. Do not screw dipstick into
housing when Checking oil level.
2. If the level is low, add ISO VG46 hydraulic oil
through the filler hole. Do not fill above the
dipstick full mark.
3. Reinstall the dipstick/filler plug A.
Changing Oil: Change the oil every 600
hours.
1. With the oil at normal operating temperature,
drain the oil by removing the rear axle
differential A and final reduction gear case
drain plugs B. Reinstall the plugs after the oil
has drained. Discard the oil.
2. Supply new ISO VG46 hydraulic oil into the fill
hole A.
NOTE: By this method, it takes much time
until the oil is spread fully into the final
reduction gear case. The oil can be supplied
by the following method also.
1. Remove the right and left rear wheels.
2. Oil supply plugs are located on the front side
of the right and left final reduction gear case.
Remove the plugs.
3. By supplying the hydraulic oil from the plug
holes, the final reduction gear case can be
filled more quickly, reducing the oil supply
time.
LUBRICATION AND MAINTENANCE
3-15
REAR AXLE DIFFERENTIAL LUBRICATION
1. Level / Filler Plug
REAR AXLE DIFFERENTIAL / FINAL REDUTION
LUBRICATION DRAIN PLUG
2. Drain Plug
A
B