ZyXEL Communications ZyWall USG 2000 User Manual page 954

Appendix A Log Descriptions
Table 283 IKE Logs (continued)
LOG MESSAGE
VPN gateway %s was
enabled
XAUTH fail! My name:
%s
XAUTH fail! Remote
user: %s
XAUTH succeed! My
name: %s
XAUTH succeed! Remote
user: %s
Dynamic Tunnel
[%s:%s:0x%x:%s] built
successfully
Dynamic Tunnel
[%s:%s:0x%x:0x%x:%s]
rekeyed successfully
Tunnel
[%s:%s:0x%x:%s] built
successfully
Tunnel
[%s:%s:0x%x:0x%x:%s]
rekeyed successfully
Tunnel [%s:%s]
1 pre-shared key
mismatch
Tunnel [%s:%s]
Recving IKE request
Tunnel [%s:%s]
Sending IKE request
Tunnel [%s:0x%x] is
disconnected
Tunnel [%s] rekeyed
successfully
Enable fall back
Disable fall back
Set fall back check
interval
Fall Back [%s]
negotiate phase 1
fail, try next time
Fall Back [%s]
negotiate phase 2
fail, please check
remote configurations
954
DESCRIPTION
%s is the gateway name. An administrator enabled the VPN
gateway.
%s is the my xauth name. This indicates that my name is
invalid.
%s is the remote xauth name. This indicates that a remote
user's name is invalid.
%s is the my xauth name. This indicates that my name is
valid.
%s is the remote xauth name. This indicate that a remote
user's name is valid
The variables represent the phase 1 name, tunnel name, SPI
and the xauth name (optional). The phase-2 tunnel
negotiation is complete.
The variables represent the phase 1 name, tunnel name, old
SPI, new SPI and the xauth name (optional). The tunnel was
rekeyed successfully.
The variables represent the phase 1 name, tunnel name, SPI
and the xauth name (optional). The phase-2 tunnel
negotiation is complete.
The variables represent the phase 1 name, tunnel name, old
SPI, new SPI and the xauth name (optional). The tunnel was
rekeyed successfully.
The variables represent the phase 1 name and tunnel name.
Phase
When negotiating phase-1, the pre-shared keys did not
match.
The variables represent the phase 1 name and tunnel name.
The device received an IKE request.
The variables represent the phase 1 name and tunnel name.
The device sent an IKE request.
The variables represent the tunnel name and the SPI of a
tunnel that was disconnected.
%s is the tunnel name. The tunnel was rekeyed successfully.
VPN fall back was enabled on the gateway.
VPN fall back was disabled on the gateway.
The fall back check time interval was changed.
The ZyWALL tried to fall back to the listed VPN gateway's
primary gateway.
When the ZyWALL tried to fall back to the listed VPN
gateway's primary gateway phase 1 negotiation passed, but
phase 2 failed.
ZyWALL USG 2000 User's Guide