ZyXEL Communications ZyWall USG 2000 User Manual page 217

Table 22 Dashboard (continued)
LABEL
IP Address
Action
Extension Slot
Slot
Device
Status
ZyWALL USG 2000 User's Guide
DESCRIPTION
This field displays the current IP address assigned to the interface. If the
IP address is 0.0.0.0, the interface is disabled or did not receive an IP
address and subnet mask via DHCP.
If this interface is a member of an active virtual router, this field displays
the IP address it is currently using. This is either the static IP address of
the interface (if it is the master) or the management IP address (if it is a
backup).
Use this field to get or to update the IP address for the interface.
Click Renew to send a new DHCP request to a DHCP server.
Click the Connect icon to have the ZyWALL try to connect a PPPoE/PPTP
interface or the auxiliary interface. If the interface cannot use one of
these ways to get or to update its IP address, this field displays n/a.
Click the Disconnect icon to stop a PPPoE/PPTP or auxiliary interface's
connection.
This section displays extension card slot and USB port status.
This field displays the name of each extension slot.
This field displays the name of the device connected to the extension slot
(or none if no device is detected). For an installed SEM (Security
Extension Module) card, this field displays what kind of SEM card is
installed.
SEM-VPN - The VPN accelerator. The SEM-VPN provides 500 Mbps VPN
throughput, 2,000 IPSec VPN tunnels, and 750 SSL VPN users.
SEM-UTM - UTM accelerator. The SEM-UTM provides 400 Mbps anti-
virus and IDP throughput.
SEM-DUAL - accelerator for both VPN and UTM. The SEM-DUAL provides
the benefits of both the ZyWALL-UTM and ZyWALL-VPN.
USB Flash Drive - Indicates a connected USB storage device and the
drive's storage capacity.
For cellular (3G) interfaces, see
status that can appear. For an installed SEM (Security Extension Module)
card, this field displays one of the following:
Active - The SEM card is working properly.
Ready to activate - The SEM was inserted while the ZyWALL was
operating. Restart the ZyWALL to use the SEM.
Driver load failed - An error occurred during the ZyWALL's attempt to
activate the SEM card. Make sure the SEM is installed properly and the
thumbscrews are tightened. If this status still displays, contact your
vendor.
Ready - A USB storage device connected to the ZyWALL is ready for the
ZyWALL to use.
Unused - The ZyWALL is unable to mount a USB storage device
connected to the ZyWALL.
Chapter 9 Dashboard
Section 10.10 on page 243 for the
217