Installing An Option Card - Lexmark T620 Setup Manual

Installing an option card

MarkNet internal print server
USB/Parallel 1284-C interface card
Warning!
Electronic components are easily damaged by
static electricity. Touch something metal on the
printer before you touch the card.
Connector 1
Connector 2
MarkNet N2501e or N2401e
Tri-Port adapter
hard disk with adapter
Your printer has two connectors that support the
following option cards:
• Hard disk with adapter card
• MarkNet™ internal print server
• USB/Parallel 1284-C Interface Card
• Parallel 1284-C Interface Card
• Coax/Twinax Adapter for SCS
• Tri-Port Adapter
Refer to the documentation included with each
card for detailed information about that specific
card.
You need a small Phillips screwdriver to install
these options.
Note: The Lexmark T622n model ships with an
Ethernet print server already installed.
1
Follow the steps in "Accessing the printer
system board" beginning on page 17.
2
Locate the card connectors on the system
board. If you are installing only one card,
install it in connector 1. If you are installing
two cards on a model with multiple
connectors, use connector 1 first and then
connector 2.
3
Locate the two screws on the back of the
printer that attach the metal plate to the slot.
4
Remove and save the two screws. Remove
and discard the plate.
5
Unpack the card. Save the packaging
materials.
21