Lexmark Printer User Manual page 286

Table 4-16: PostScript Emulation System Parameters (Continued)
Key
DoPrintErrors
DoStartPage
1
EnableExtraFonts
1
EngineBoot
1
EngineCode
1
EngineSpeed
2
EnvironmentSave
FactoryDefaults
FatalErrorAddress
FontResourceDir
1
FontVersion
GenericResourceDir
GenericResourcePathSep
1
These parameters are Lexmark-specific and are in addition to the Adobe PostScript Language Supplement 2016.
2
These parameters are available with the Adobe PostScript Language Supplement 3010.
3
These parameters are Lexmark-specific and are in addition to the Adobe PostScript Language Supplement 3010.
Type Definition
boolean Specifies whether to print an error page using a built-in error
handler when a PostScript emulation error occurs.
True
False
boolean (Read only) Always returns False.
boolean True
False
Note: Changes to this parameter take effect when PostScript
is restarted.
string (Read-only) Specifies the version of the boot code.
string (Read-only) Specifies the version of the engine code.
integer (Read-only) Maximum speed of the print engine in pages per
minute.
boolean Indicates or modifies the
True
False
Note: When a job changes this parameter from False to True,
all interpreter tasks such as PostScript and PCL are
terminated and restarted at the end of the current job.
boolean If set to True and the printer is then immediately powered off,
all non-volatile parameters revert to factory default values at
the next power-on. The print job that sets FactoryDefaults to
True must be the last job executed before power-off;
otherwise, the request is ignored.
integer The address at which a fatal system software error occurred.
It is stored in this parameter before execution is stopped. It is
also transmitted to the host over the communications
channel.
string Specifies the location in the file system for font resource files.
string (Read-only) The version of the font read-only memory (ROM).
string Specifies the location in the file system for resource files.
string Concatenated to the GenericResourceDir and the category
name. It is followed by the resource name to get the external
location of the resource.
Example: If GenericResourceDir and
GenericResourcePathSep were (Resource/) and (/),
respectively, the LexmarkLogo resource of the Pattern
category would be in Resource/Pattern/LexmarkLogo.
4-81
Print PS Error user default value is set to On.
user default value is set to Off.
Print PS Error
All 75 resident fonts are enabled.
Original 39 PostScript fonts are available.
user default value.
Resource Save
user default value is set to On.
Resource Save
user default value is set to Off.
Resource Save
PostScript