Unlocking A Protected File Or Device - Lexmark Printer User Manual

Unlocking a Protected File or Device

Use the LDECLARE command to specify a password so a protected file or device may
be accessed or "unlocked." The LDECLARE command is only allowed within a JOB/
EOJ combination.
LRWLOCK with LDECLARE specified unlocks a file or device for reading and writing.
LWLOCK with LDECLARE specified unlocks a file or device for writing only. The file
or device must be re-locked using the LDELETEPASSWORD command after the job
is completed. The file or device is not automatically re-locked with the EOJ command.
Syntax:
Values for "
Note:
,
A unique identifier for a file, such as the macro ID for a PCL
macro, the symbol set ID for a PCL symbol set, the font ID for a
PCL font, or the actual file name for data, Type 1 fonts, and
demo files as shown on the Directory. The
sensitive.
An identifier that categorizes the file, such as
macros or
beginning on page 3-87 for a complete list of the supported file
types. The
or
See "Printer Unique LRESOURCE Variables" on page 3-52 for information
about values for
This should be the same password that was defined in the DEFAULT
command. See "Password Protection for a File" on page 3-93 and "Password
for an Entire Device" on page 3-94 for examples.
3-95
" are:
, , or (case insensitive)
for PCL symbol sets. See the table
is case sensitive.
and
PJL
is case
for PCL
parameters.