Setting The Marknet Xle Tcp/Ip Protocol Settings; Setting The Marknet Xle Job Timeout; Setting The Marknet Xle Busy Timeout - Lexmark Optra K 1220 Installation And User Manual

5.4.2 Setting the MarkNet XLe TCP/IP Protocol Settings

The following TCP/IP protocol settings must be set in order for the host to send jobs to
the printer through the MarkNet XLe. Contact your network administrator if you need
help with these settings.
Activate
Set IP Address
(Address available from your network administrator)
Set IP Netmask
(Appropriate netmask for your network)
Set IP Gateway

5.4.3 Setting the MarkNet XLe Job Timeout

The recommended setting for the MarkNet XLe Job Timeout is 0 (disabled). This
allows the host system "release timer" value to control when print jobs from another
protocol, interface, server, or host can be started.
You may set the MarkNet XLe Job Timeout value to a value greater than the host
"release timer" value. Errors are very likely to occur when the printer requires user
intervention and the intervention is not cleared before the timeout occurs.
Setting the MarkNet XLe Job Timeout smaller than the host "release timer" value will
result in communication errors after the job has printed.

5.4.4 Setting the MarkNet XLe Busy Timeout

The recommended setting for the MarkNet XLe Busy Timeout is 0 (disabled). This
allows the host system "release timer" value to control when print jobs from another
protocol, interface, server, or host can be started.
You may set the MarkNet XLe Busy Timeout value to a value greater than the host
"release timer" value. Errors are very likely to occur when the printer requires user
intervention and the intervention is not cleared before the timeout occurs.
72
Yes
157.184.67.102
255.255.255.0
157.184.67.1 (IP address of the IP gateway)