Using The Coax Interface With Ipds; Ipds Enabled Setting - Lexmark Optra K 1220 Installation And User Manual

6.2 Using the Coax Interface with IPDS

Note: When coax attached, the SCS adapter will, by default, use the IPDS
emulation if a SIMM for IPDS is installed. If you install a new SCS adapter
in an Optra printer with a SIMM for IPDS (and vice versa), you do not need
to configure the SCS adapter to use the IPDS emulation.

6.3 IPDS Enabled Setting

This is a setting on the SCS adapter, which only appears when the SIMM for IPDS is
detected in the printer. The default is "Yes" (IPDS is enabled).
From the printer operator panel, do the following:
1. Press Menu> until NETWORK MENU displays. Press Select.
2. Press Menu> until NETWORK OPTION 1 displays. Press Select. (This
example assume the SCS Adapter is installed in option connector 1.)
3. Press Menu> until you see SCS MENU 1. Press Select.
4. Press Menu> until you see IPDS OPTION. Press Select.
Here you find the setting:
IPDS Enabled
To pass IPDS or SCS data to the SIMM for IPDS, select "Yes".
To pass only SCS data to the SIMM for IPDS, select "No".
Note: Changes to this setting become active only after the printer is powered
Off and then powered On.
Yes*
No
105