5.2.1 Selecting the MarkNet S TCP/IP Protocol Settings
From the printer operator panel, do the following:
1.
Press Menu> until the NETWORK MENU displays. Press Select.
2.
Press Menu> until the NETWORK OPTION 1 displays. Press Select.
(This example assumes the MarkNet S Adapter is installed in option
connector 1.)
3.
Press Menu> until you see NETWORK 1 SETUP. Press Select.
4.
Press Menu> until you see TCP/IP. Press Select.
Here you find the following settings:
Activate
Enable BOOTP
(Yes, if you use a BOOTP server.)
(No, if you set the IP address another way.)
Enable DHCP
(Yes, if you use a DHCP server.)
(No, if you set the IP address another way.)
Enable RARP
(Yes, if you use a RARP server.)
(No, if you set the IP address another way.)
Set IP Address
(Address available from your network administrator)
Set IP Netmask
(Appropriate netmask for your network)
Set IP Gateway
Set Hostname
Yes
Yes or No
Yes or No
Yes or No
157.184.67.102
255.255.255.0
157.184.67.1 (IP address of the IP gateway)
Name (Necessary when using DHCP server.)
67