Table of Contents
Advertisement
Service instructions
Always disconnect the gas supply and power before servicing
the cooker.
After service always check connections for gas soundness at
connections with soapy water. NEVER use a naked flame to check
for leaks.
To remove glass lid (for cookers fitted with a glass lid)
Service and maintenance
must only be carried out
1. Place lid in the open position.
by an authorised person
2. Lift the lid out of the hinge brackets.
3. Store in a safe place.
To remove upstand (for cookers fitted with upstand)
1. Pull cooker forward.
2. To remove the retaining brackets, situated either side of the
hob rear, undo the 2 top and 2 rear retaining screws securing
each bracket.
3. Lift the upstand from the cooker hob.
Access to under hob area
1. Remove the glass lid/upstand brackets as per heading 'To
remove upstand'.
2. Remove pan supports, burner caps and burner heads.
3. Using a torx T20 head driver remove the screws securing the
burners to the hob. 2 per boiling burner and 4 for the wok
burner.
4. Lift hob at rear and slide out of position.
5. Reassemble in reverse order. Ensure that the hob engages
the securing slot at the front.
To replace the gas control valves or gas manifold
Pull cooker forwards to gain access to the rear of the appliance
and follow procedure above to gain access to under hob area.
1. Disconnect gas supply line to cooker.
2. Remove the control knobs.
3. Remove the control fascia panel by using a phillips head
screwdriver to remove 2 screws either side from inside the
underhob area. Leave fascia hanging.
4. Disconnect all burner supply pipes at manifold.
5. Disconnect spark ignition modules from valves.
6. The whole burner assembly can now be pulled towards the
rear, to service the gas manifold.
7. To replace a valve unscrew gas valve from manifold.
8. Reassemble in reverse order. Ensure gas tightness to gas
manifold assembly.
Important
Check correct operation of each burner individually and in
24
Energy consumption
Burners
Small
Medium
Large
Wok
Oven
(Gas)
Grill
Test the operation of the cooker before leaving
Note: these burners have no aeration adjustment.
Check correct operation of the ignition system and operation of
burners individually and in combination. Burner flames should
be clear blue, with no yellow tipping. If the burners show any
abnormality check that the burner heads are correctly located. If
satisfactory performance can not be obtained, contact
SampfordIXL or the local gas utility.
Important
Before leaving instruct the owner in the use of the cooker.
Warranty warning
It should be expressly noted that we cannot accept any liability
for direct or indirect damage caused be wrong connection or
improper installation. When being repaired, the appliance must
always be disconnected from the mains supply; is required, notify
our customer service.
For service to this appliance
This appliance is imported
For service to this appliance please contact:
and distributed by:
SampfordIXL P/L
52-70 Sparks Avenue
Fairfield. Vic, 3078
Phone: 1300 727 421
Fax:
1300 727 425
Email: service@sampfordixl.com.au
Gas type
Pressure (kPa)
Injector (mm)
Mj/hr
Natural
1.0
0.90
LPG
2.75
0.54
Natural
1.0
1.18
LPG
2.75
0.70
Natural
1.0
1.55
12.50
LPG
2.75
0.92
11.25
Natural
1.0
1.65
LPG
2.75
0.95
Natural
1.0
1.80
LPG
2.75
1.10
Watts
3.85
-
3.75
-
7.12
-
6.20
-
13.1
-
13.1
-
16.5
16.6
2300 W
9
Hide quick links:
Advertisement
Table of Contents
