Table of Contents
Advertisement
6. Feed the thermostat bulb down the rear cavity and through
the access hole in the rear oven wall. Clip bulb into the two
retaining brackets.
7. Reconnect electronic connectors.
8. Reassemble in reverse order.
To remove side panels
Pull cooker forward to gain access to the rear of the cooker and
follow procedure as per heading 'Access to under hob area'.
1. Remove 3 phillips head screws at the rear flange of the
panels.
2. Remove the screw either side at front securing side panels to
fascia support plate.
3. Remove phllips head screws down front flange of panels.
4. Remove the panels.
5. Reassemble in reverse order.
To remove the oven door
1. Swing the spring levers upwards to a vertical position, lift
door slightly and remove by pulling forward. Store in a safe
place.
2. To replace engage the hinges into the hinge holes, place
door in horizontal position and swing hinge lugs downwards.
3. Close door to re-engage the springs.
To replace oven thermocouple
1. Remove oven door as per the heading 'To remove the oven
door'.
2. Remove left hand side panel as per the heading 'To remove
side panels'.
3. Undo the thermocouple sensor lead at the rear of the
thermostat.
4. Remove the 2 phillips head screws securing the oven floor at
the front.
5. Lift oven floor at the rear and slide floor backwards to
disengage at the front and remove.
6. Remove the flame diffuser position above the burner by using
a 7 mm spanner to undo the 3 retaining nuts.
7. Remove the spring clip retaining the thermocouple to the
support bracket.
8. Replace the thermocouple and secure into position with the
spring clip.
9. Thread sensor lead down the rear cavity of the cooker and
screw opposite end of thermocouple to the rear of the
thermostat.
10.Reassemble in reverse order.
26
Side clearances to vertical surface:-
If the distance measured from the periphery of the nearest burner
to any vertical combustible surface, is less than 200 mm, the
surface shall be protected in accordance with clause 5.12.1.1
and 5.12.1.2 of AS 5601.
Make sure the minimum clearances to combustible materials are
maintained during the installation including adequate space for
the operation and servicing of the cooker.
Overall dimensions: (with legs adjusted to 180mm)
Height over hob:
910 mm
Height over upstand:
980 mm
Height over lid:
1510 mm
Width:
895 mm
Depth (flush with oven door): 610 mm
Depth(incl. oven door
handle & knobs:
660mm
Note: for stainless steel cookers fitted with an upstand an optional
glass lid is available. Part no: LL01-90-S.
For height limitations use dimensions as shown in the drawing
above.
7
Hide quick links:
Advertisement
Table of Contents
