Support Legs - La Germania LUG03-90-S Instruction Manual

Support legs

The cooker is fitted with four transit supports. (One for each
corner).
4 support legs are supplied separately and are fitted on location
to the four corners of the lower support frame. Each support leg
is pushed over the relevant transit support until it is flush with the
support frame.
Each leg is adjusted by screwing the lower section in or out as
required for fitting to a 900 mm standard bench height. For
lower bench tops adjust height as required. The adjustment range
for the leg is 150 - 185mm. With the legs adjusted to a height of
180mm the cooker hob is located 10mm above the horizontal
combustible surface, ref. AS 5601 fig 5.1.
If the legs are not used and the cooker is mounted onto a plinth,
leave the transit support in situ to allow for clearance.
10
Cleaning oven glass door
The oven door may be removed for cleaning. To remove the
oven door follow these steps:
1. Open the door fully.
2. Lift the two levers forward as shown in figure below left.
3. Close the door as far as the first stop (created by the raised
levers).
4. Lift the door upwards and outwards to remove it from its
mounting as shown in figure below right.
5. To replace the door, fit the hinges on their mountings and
lower the levers.
6. Close the door.
❍ Use a window cleaner to clean the exterior glass panel.
Replacing the oven light bulb
Type: E14, 25W, heat resistant to 300°C.
You may obtain this bulb from our service department as listed
in the rear of this booklet or from your LaGermania retailer.
1. Disconnect the appliance from the main electricity supply.
2. To prevent damage place a teacloth in the bottom of the
oven.
3. Unscrew the glass cover of the light.
4. Unscrew the old lightbulb and
replace it with a new one.
5. Replace cover.
6. Reconnect the power supply.
23