Table of Contents
Advertisement
Installation instructions
Statutory regulations
This appliance shall be installed in accordance with the
manufacturer's installation instructions, local gas fitting
regulations, municipal building codes, electrical wiring
regulations, and AS 5601 the Australian Standard for gas
installations. Refer also to AS 5601 for pipe sizing tables.
Gas supply
Check that the data plate shows the appliance is suitable for the
available gas supply. The data plate is located on the inside of
the oven door, centre bottom. A copy of the data is also
reproduced in this booklet on page 30.
Electrical supply
Requires connection to a 10 Amp wall socket.
Instructions
1. The model number and the type of appliance, gas pressure
and gas type are found on the inside centre front of the oven
door, centre bottom.
2. The appliance requires connection to a 240 V, 50 Hz
electric supply. The power point must be installed by an
authorized person.
3. Before commencing any work, make sure that the power point
switches are turned off and the three in plug is removed.
4. If the appliance cannot be adjusted to perform correctly
contact SampfordIXL or the local gas utility. For service contact
telephone number refer page 9.
5. Instruct the user in the operation of the appliance before
leaving.
Vertical clearances:-
The cooker shall be installed so that a vertical clearance of at
least 600 mm is maintained between its burners and any
combustible material and, where this is not practicable, the
underside of any combustible material less than 600 mm above
the burner shall be protected by noncombustible millboard at
least 6 mm thick which is covered with sheet metal not less than
0.4 mm thick, or shall be protected by an equivalent material,
extending at least 225 mm beyond the sides of the cooker.
Overhead clearances:-
Range hoods and exhaust fans shall be installed in accordance
with the manufacturer's instructions. However, in no case shall
the clearance between the top of the highest burner of the
cooking appliance and the underside of a range hood be less
than 600 mm, or an overhead exhaust fan, 750 mm.
6
To replace electronic ignition module
Follow procedure described as per the heading 'Access to under
hob area'.
1. The electronic ignition module is clamped to the RHS burner
support bracket.
2. Unplug the electrical connectors. Mark the connectors to
replace them in the correct order.
3. Push the spring clips together to remove the module.
4. Replace the module by pushing the spring clips into position
and reconnect the electrical connectors in the right order.
5. Reassemble in reverse order.
To replace the grill element
Pull cooker forward to gain access to the rear of the cooker.
1. Remove cooker rear cover by unscrewing 7 phillips head
screws.
2. Disconnect the electric wiring to the element at the rear of
the oven.
3. The grill element is secured to the roof of the oven by 2
screws at top of oven rear panel and a holding bracket at
centre front of the oven roof. To remove the grill element
unscrew the 2 screws at the rear and 1 screw securing the
retention bracket at the front.
4. Replace the grill element.
5. Reassemble in reverse order.
To replace the oven electronic ignition electrode
Remove left hand side panel in as per the headings 'To replace
oven thermocouple'.
1. Remove the spring clips retaining the electronic spark ignitor
to the oven burner and remove the spark ignitor.
2. Disconnect the spark ignitor lead from the electronic control
module. The spark ignitor lead is white with a diagonal red
stripe.
3. Replace the new spark ignitor, ensuring the spring clip retains
the spark in the correct position.
4. Reconnect the lead to the electronic control module.
5. Reassemble in reverse order.
To replace the oven door inner glass panel
1. Remove oven door as per heading 'To remove the oven door'.
2. Place oven door, glass side down, on a even horizontal
surface.
3. Remove the 4 holding brackets which secure the glass to the
door by undoing 4 phillips head screws.
4. Replace the glass panel and reassemble in reverse order.
27
Hide quick links:
Advertisement
Table of Contents
