Setting Barrel (Molten Rod) Temperature; Setting Pre-Heat Air Temperature; Feeding Rod - Demtech Pro-X 600-0100 Instruction Manual

2. SETTING BARREL (MOLTEN ROD) TEMPERATURE

To display current barrel temperature set point, press and hold blue "set" button located on the bottom
temperature controller. To adjust set point, press up or down arrow buttons while holding down "set"
button.

3. SETTING PRE-HEAT AIR TEMPERATURE

To display current pre-heat air temperature set point, press and hold blue "set" button located on the top
temperature controller. To adjust set point, press up or down arrow buttons while holding down "set"
button.
NOTE:
Once temperatures have been adjusted to desired settings, allow 5 minutes for barrel
and air temperatures to rise and stabilize to set points before attempting to feed
welding rod. The Pro-X is equipped with electronic "cold start" protection.
However, feeding rod before barrel temperature has reached set point can cause
damage to drive motor unit.
4. FEEDING WELDING ROD
Start drive motor by pulling trigger switch and lock in the "on" position by depressing lock button and
then releasing trigger. Molten extrudate may or may not begin to exit Teflon welding shoe depending on
how well the unit was purged after its last use.
While drive motor is on insert 4 or 5mm welding rod into the rod feed hole located on barrel near
adjustable handle mount. Apply inward pressure until rod begins to feed without assistance. Molten
material (extrudate) will begin to extrude from end of Teflon welding shoe. Upon initial start-up, allow
extrudate to flow for 5 to 10 seconds, purging any residual material from previous use, then turn drive
motor off by pulling and releasing trigger.
You may now proceed with welding operations.
7