General Safety Information (Safety); Intended Use; Maintenance Advice - Demtech Pro-X 600-0100 Instruction Manual

GENERAL SAFETY INFORMATION
The Pro-X is a high voltage piece of equipment. Always disconnect the power source before
performing service and maintenance to the unit.
Never pull or carry welder by the power cord or electrical connection. Always keep slack in
extension cord while in operation to avoid damage to the power connection.
Keep hands and other body parts clear of hot air nozzle and elements when hot.
Always use Pro-X in a well-ventilated area when welding materials that produce toxic fumes. Do not
inhale toxic fumes when present.
Do not operate near flammable materials. Do not apply flammable liquids to seam area.
Allow unit to cool down for at least 5 minutes before putting it back into shipping/storage case.
Protect unit from exposure to direct rainfall or standing water. Never attempt to weld in standing
water.

1. INTENDED USE

The Pro-X extrusion welder has been manufactured according to the latest technology and current safety
regulations. However, improper use or abuse may lead to hazardous conditions for the user or third party
or damage to the unit.
Always have this manual handy at the location where the Pro-X is being used so that it can be referred to
quickly and easily.
The technician assigned to operate this welder must have read through and become familiar with this
manual before staring work.
Do not make changes or modifications to the Pro-X relative to safety without contacting the
manufacturer for advice.
2. MAINTENANCE
Maintenance, inspection, and adjustment of the Pro-X may only be carried out by qualified personnel.
Before removing or installing spare parts or performing other repair operations to the Pro-X, consult the
manufacturer for advice on proper procedures. This will help insure a safe and successful outcome.
Always make sure all screw connections are tight before attempting to operate the unit after maintenance
or repair. Also make sure all covers, guards, and other safety devices have been reinstalled before use.
SAFETY
3