Operating Procedure (Operation); Power-Up; Setting/Adjusting Operating Temperatures; Recommended Temperature Settings - Demtech Pro-X 600-0100 Instruction Manual

Demtech pro-x 600-0100 high output extrusion welder

Table of Contents

OPERATION

OPERATING PROCEDURE

Connect Pro-X power cord to power source making sure that the voltage is correct for the model of

welder you have. Please refer to page 4 and 5 of this manual for details.

Both temperature controllers should illuminate and display current temperature of barrel and pre-heat air

(usually ambient temperature when starting-up for the first time that day).

Switch the pre-heat blower fan rocker switch located on the control panel to the "on" position (up). The

hot air blower unit, situated on top of the welder should turn on and air should begin blowing out of pre-

heat nozzle at the end of the barrel.

Switch the pre-heater element rocker switch located on the rear of the green colored pre-heat blower unit

to the on or "I" position. This will allow the pre-heat air to begin heating.

Note:

There are two temperature controllers located on the main control panel. The one on

the top controls the hot air pre-heat temperature and the one on the bottom controls

the barrel (molten rod) temperature.

For recommended temperature settings, please refer to chart below or contact

Demtech technical support for advice.

Temperature setting will vary a great deal due to the wide range of variables that can be experienced in

the field. For example, ambient temperature, sheet temperature, sheet thickness, wind conditions, etc.

will vary. As it is difficult to create a chart that covers all conditions, we recommend contacting Demtech

with information on the above conditions. We will be happy to recommend appropriate settings.

Table of Contents