Table of Contents
Advertisement
5055-01x
6. Pull the transfer belt out.
7. After replacing the transfer belt and removing the four shipping
spacers, tighten the transfer belt thumbscrews and reinstall the
transfer belt cover.
8. Close the top unit and rotate the locking lever to the right, close
the front cover.
9. Turn the printer on.
Note: If the message Did you Replace Belt? appears, wait for the
message Select = yes Stop = no and press Select.
If you replaced the belt before the Life Warning or Exhausted
message appeared, open the supplies menu on the operator panel
and select Replace Supplies, then select Belt, and select
Replaced. The message Printing Alignment Page appears and
the printer prints the alignment page.
Follow the instructions on the display to set the alignment values for
the new transfer belt.
Repair Information
4-33
Advertisement
Table of Contents
