Macro Knob - Ruin & Wesen Midi Command User Manual

Ruin & Wesen Electronics
new current patch. You can then adjust the parameters using the control encoders (2), and switch pages as described in
the paragraph above.
Page number
Patch number
Turn menu encoder
The factory patches of the MIDI Command are described in the appendix "Factory patches".

Macro Knob

Each parameter page features 4 parameters that can be directly controlled using the control encoders (2). In addition to
these 4 encoders, the Midi Command features a Macro Knob that is controlled by turning the menu encoder. The Macro
Knob allows you to modify the 4 page parameters by twisting a single knob. You can adjust the range inside which each
page parameter is modified by editing the Macro Knob settings (see the section Macro Knob Settings below). You can
set the lower boundary and upper boundary for each parameter independently. For example, you could configure the
Macro Knob to modify the first parameter from 30 to 60, the second parameter from 60 to 30, the third parameter from 0
to 127 and the fourth parameter from 127 to 0.
Midi Command Documentation
PAGE 2
LOADING PATCH 2
Switching patches
Hold shift down
7