Ruin & Wesen Midi Command User Manual page 27

Ruin & Wesen Electronics
Midi Byte
page type
page data (8bit data)
0xF7
Get Patch message
This message is used to ask the Midi Command to send a patch over MIDI. The Midi Command will respond by sending
4 SEND_PAGE messages (see above) with the content of the patch.
Midi Byte
(Sysex Header)
0x13
patch number
0xF7
Switch Patch message
This message is used to ask the Midi Command to load a patch from patch memory.
Midi Byte
(Sysex Header)
0x12
patch number
0xF7
Set Flash message
This message is used to make the Midi Command flash 2 lines of text on its display..
Midi Byte
(Sysex Header)
0x15
flash data (32 8-bit bytes)
0xF7
Midi Command Documentation
Purpose
page type: 0 for MIDI page, 1 for MD
Reverb page, 2 for MD Echo page, 3
for MD EQ page, 4 for MD
Compressor page)
8-bit encoded page data (see section
"Page formats" below)
MIDI Sysex END
Purpose
CMD = CMD_GET_PATCH
patch number (from 0 to 7)
MIDI Sysex END
Purpose
CMD = CMD_SWITCH_PATCH
patch number (from 0 to 7)
MIDI Sysex END
Purpose
CMD = CMD_SET_FLASH
two times 16 bytes, one for the upper
row of the LCD, one for the lower row
of the LCD
MIDI Sysex END
27