When You Want To Save A Scanner Driver Setting - Canon imageFORMULA P-215II User Manual

1
When you want to specify different scanning conditions for the front
and back pages of a document, select [Skip blank page] or [Duplex]
for [Scanning Side] on the [Basic] tab in advance.
2
Specify the number of scanning conditions to apply in [Stream count
of Front]. Up to three can be specified.
3
Select [Front 1st], and then open the other tabs and set the scanning
conditions. Depending on the value specified for [Stream count of
Front], configure the remaining [Front 2nd] and [Front 3rd] in the
same way.
4
When specifying the scanning conditions of the back, configure the
settings in the same way as described in B to C. In this case, specify
[Stream count of Back], and then set the scanning conditions for
each of [Back 1st] to [Back 3rd].
The following shows the setting conditions that can be set in the
multistream settings.
Tab
[Basic] tab [Color mode] and [Dots per inch] (excluding
[Detect automatically] for both)
[Brightness] tab [Brightness] and [Contrast]
[Image processing] tab [Edge emphasis], [Color drop-out] and [Character
Emphasis]
[Feeding] tab None (all disabled)
[Others] tab None (only [Use MultiStream] is enabled)
Downloaded from ManualsPrinter.com Manuals
Items that can be set
Practical Examples

When you want to save a scanner driver setting

When you finish configuring a setting, click the [Save] button of [User
Preference] to save the setting.
The saved setting is registered to the list. You can delete a setting from the
list with the [Delete] button, and save or load a configuration file with the
[Back Up] or [Restore] button.
The preregistered [Full Automatic Mode] cannot be deleted from
[User Preference].
94