Table of Contents
Advertisement
Table 18 - Troubleshooting
Problem
Indicator
System boot
failure
60
Mellanox Technologies
Symptoms
The last software upgrade
failed on PPC based sys-
tems
Corrective Measures
•
Make sure that there is an SM running in the fabric.
•
Connect the RS232 connector (CONSOLE) to a
laptop.
•
Push the reset button on the system or on the man-
agement module.
•
You will have ~ 5 seconds to stop the U-Boot by
pressing Control-B.
•
Choose the image you wish to upload. Use image 1
or image 2 only.
•
Select the previous image to boot.
U-Boot 2009.01-mlnx1.4 (<date>)
CPU:
AMCC PowerPC 460EX Rev. A at 1000 MHz
(PLB=200, OPB=100, EBC=100 MHz)
Security/Kasumi support
Bootstrap Option H - Boot ROM Location
I2C (Addr 0x52)
Internal PCI arbiter disabled
32 kB I-Cache 32 kB D-Cache
Board: Mellanox PPC460EX Board
FDEF: No
I2C:
ready
DRAM:
2 GB (ECC enabled, 400 MHz, CL3)
FLASH: 16 MB
NAND: 1024 MiB
PCI:
Bus Dev VenId DevId Class Int
PCIE0: link is not up.
PCIE1: successfully set as root-complex
01 00 15b3 bd34 0c06 00
Net:
ppc_4xx_eth0, ppc_4xx_eth1
Hit Ctrl+B to stop autoboot: 0
Mellanox MLNX-OS
Boot Menu:
1. SX_PPC_M460EX 3.3.5006-dev-HA 2013-04-
10 12:02:49 ppc
2. SX_PPC_M460EX 3.3.5006-dev-HA 2013-04-
11 14:05:39 ppc
3. U-Boot prompt
Choice:
Troubleshooting
Advertisement
Table of Contents
