Table of Contents
Advertisement
To insert a power supply unit:
Make sure the mating connector of the new unit is free of any dirt and/or obstacles.
Step 1.
Insert the power supply unit by sliding it into the opening until a slight resistance is felt.
Step 2.
Continue pressing the power supply unit until it seats completely. The latch will snap into
Step 3.
place, confirming the proper installation.
Insert the power cord into the supply connector.
Step 4.
Insert the other end of the power cord into an outlet of the correct voltage.
Step 5.
44
Mellanox Technologies
Figure 26: Power Supply Unit Extraction
OK
!
Push Here
Figure 27: PS Unit Pulled Out
Do not attempt to insert a power supply unit with a power cord connected to it.
The green power supply unit indicator should light. If not, repeat the whole procedure
to extract the power supply unit and re-insert it.
Latch release
OK
OK
!
!
Installation
Advertisement
Table of Contents
