Mellanox Technologies SX6005 User Manual page 40

Table 10 - Configuration Wizard Session - DHCP
Step 4: Enable IPv6 auto-config
(SLAAC) on mgmt0 interface?
[no]
Step 5: Enable DHCPv6 on
mgmt0 interface? [no]
Step 6: Admin password (Press
<Enter> to leave unchanged)?
<new_password>
Step 6: Confirm admin pass-
word? <new_password>
You have entered the following
information:
<A summary of the configura-
tion is now displayed.>
To change an answer, enter the
step number to return to or hit
<enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
The table below shows an example of static IP configuration for mgmt0 interface.
40 Mellanox Technologies
Wizard Session Display
This turns on auto-configuration of the IPv6 addresses. This is
unsuitable for DHCPv6.
If you enter "no" (no IPv6), you will automatically be referred to
Step 6.
To enable DHCPv6 on the MGMT0 interface.
To avoid illegal access to the machine, please type a password and
then press <Enter>. Then confirm the password by re-entering it.
Note that password characters are not printed.
The wizard displays a summary of your choices and then asks you
to confirm the choices or to re-edit them.
Either press <Enter> to save changes and exit, or enter the configu-
ration step number that you wish to return to.
Note:
To re-run the configuration wizard, run the command "configura-
tion jump-start" in Config mode.
Comments
Installation