Lexmark X502N User Manual page 92

Menu item
PBX Access Digit
xxx
Default Mode
Copy
Fax
Auto Clear
Off
On
30 sec
1 min.
2 min.
3 min.
5 min.
10 min.
Power Saver
Off
On
Wait 1–240min
Display Language
ENGLISH
FRENCH
GERMAN
ITALIAN
SPANISH
Country Code
<list of country codes>
Description
Specifies an outside line dispatch number
Notes:
•
9 is the factory default setting.
•
Any number from 1–999 can be used.
Specifies whether the printer will be in Fax mode or Copy
mode following either of these two events:
•
The printer is turned on.
•
The Auto Clear setting times out.
Note: Copy is the factory default setting.
Sets whether the printer automatically returns to the Default
Mode setting after the set amount of time if no operation is
done during that time
Notes:
•
On (30 sec) is the factory default setting.
•
Off disables the Auto Clear function.
Sets the amount of time in minutes the printer waits after a job
is printed before it goes into a reduced power state
Notes:
•
On (30 min.) is the factory default setting.
•
Lower settings conserve more energy, but may require
longer warm-up times.
•
Select the lowest setting if the printer shares an electrical
circuit with room lighting or you notice lights flickering in
the room.
•
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print
with minimum warm-up time.
Selects the language of the text appearing on the display
Sets the country or region where the printer is being used
Note: The Country Code must be set correctly for the fax
function to work properly.
92