Understanding The Dialing Options; Customizing Dial Settings; Setting The Dialing Mode; Adjusting The Volume - Lexmark X502N User Manual

Understanding the dialing options

Dialing option
Manual dialing
Quick dialing
Speed dialing
Redial

Customizing dial settings

Setting the dialing mode

Depending on the type of phone line being used, the printer can be set to Touch Tone or Pulse dialing. The factory
default setting is Touch Tone.
1
From the control panel, press
2
Press or repeatedly until Admin Settings appears, and then press
3
Press or repeatedly until TEL Line Type appears, and then press
4
Press or repeatedly until the dialing mode you want appears, and then press
5
Press to return to the Ready state.

Adjusting the volume

The volume can be adjusted for the keypad, telephone ring, line monitor, end tone, and alarm.
Volume setting
Keypad Volume
Ring Volume
Line Mon. Vol
Job End Tone Vol
Job Error Tone Vol
Alarm Volume
Description
Manually type the fax number using the keypad.
Press the Quick Dial button that stores the number you want to call.
Note: To dial Quick Dial numbers 11–20, press the Shift button, and then
press the Quick Dial button that corresponds to the number you want to
dial.
Press the Directory button, followed by a Speed Dial number.
Note: If Not Registered # appears when you enter the Speed Dial
number, then a number has not been stored at this location.
If you are sending a fax manually and the line is busy, press Redial /
Pause, and then press
Note: If you are sending a fax automatically and the line is busy, the printer
will automatically redial one time after five minutes.
.
Description
Sets the volume of the beep that sounds when a key is pressed.
Sets the ring volume.
Sets the dialing and on-hook volume.
Sets whether the printer sounds a one-second end tone.
Sets whether the printer sounds a four-second end tone.
Sets the alarm volume.
67
to try again.
.
.
.