CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free cloth moistened with any good
glass cleaning fluid. Never use alcohol or solvents!
There are no servicable parts inside the device except for the lamp and the fuse. Maintenance and service
operations are only to be carried out by authorized dealers.
Please refer to the instructions under "Installing/Replacing the lamps".
Replacing the fuse
If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating (T 2 A, 250 V).
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
The lens has to be replaced w hen it is obviously dam aged,
so that its function is im paired, e. g. due to cracks or deep scratches!
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Power supply:
Power consumption:
DMX-control-channels:
DMX-512-connection:
Blackout-connection:
Sound-control:
Radiation angle:
Range of action:
PAN-movement:
TILT-movement:
Flash-rate:
Number of colours:
Number of gobos:
Dimensions (LxWxH):
Weight:
Fitting lamps:
Maximum ambient temperature t
Maximum housing temperature t
Fuse:
Please note: errors and omissions for every information given in this manual excepted. Every
information is subject to change without prior notice. 3/00 ©
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
:
a
(steady state):
B
CAUTION!
230 V/50 Hz
200 W
16/14
3-pin XLR
¼" mono jack
via built-in microphone
18°
3 - 6 m
within 130°
within 90°
1-5 Hz
7 dichroic + white
9 gobos, 1 bicolor-gobo and open
445 x 225 x 140 mm
6 kg
EFR 15 V/150 W GZ-6,35
45° C
70° C
T 2 A, 250 V
22
Need help?
Do you have a question about the TS-3 DMX-Scanner and is the answer not in the manual?
Questions and answers