Yamaha CRYPTON T110C Owner's Manual page 64

PERIODIC MAINTENANCE AND ADJUSTMENT
3
1. Brake torque rod
2. Brake torque rod cotter pin
3. Brake torque rod nut and bolt
7. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod from the brake cam-
6
shaft lever.
5
1
4
2
1. Washer
2. Axle nut
3. Brake rod
4. Brake pedal free play adjusting nut
5. Brake camshaft lever
8. Remove the axle nut and the
washer, and then pull the wheel
axle out.
1. Wheel axle
1
2
TIP
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
3
10. Remove the wheel.
To install the rear wheel
1
6-34
9. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
1. Install the wheel by inserting the
wheel axle from the left-hand side.
2. Install the drive chain onto the rear
sprocket.
3. Install the washer and the axle nut.
4. Install the brake rod onto the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
5. Connect the brake torque rod to
the brake shoe plate by installing
the bolt, the washer and the nut.
6. Adjust the drive chain slack. (See
page 6-18.)
7. Tighten the brake torque rod nut
and axle nut to the specified
torques.
EAU47700