Advertisement
Chapter 1: Product Introduction
Thank you for choosing the Signamax model 065-7341G Gigabit Ethernet
Switch.
1.1 Product Overview
The Signamax model 065-7341G is powered by Gigabit Ethernet technology. It
provides a seamless network connection which can speed up your Local Area
Network to 1000 Mbps.
The Signamax 065-7341G switch is compatible with all 10/100/1000BaseT/TX
Ethernet devices, which protects your existing network investments while
providing you with a straightforward migration path to Gigabit Ethernet speed.
The 065-7341A switch is very easy to incorporate into your Local Area Network,
since it is plug-and-play and no configuration is needed. In addition, the
Auto-MDI/MDIX cable detection on all ports eliminates the need for specialized
crossover cables. Each port can be simply plugged into a server, a hub, a router,
a switch or a PC, using either a straight cable or a crossover cable. Diagnostic
LEDs, which display link status and activity, allow you to detect and correct
problems on the network.
Features
Complies with IEEE 802.3 10BaseT, IEEE 802.3u 100BaseTX, and IEEE
•
802.3ab 1000BaseT standards.
All 24 of the 10/100/1000Mbps RJ-45 ports support Auto-MDI/MDIX.
•
Supports IEEE 802.3x flow control for full-duplex mode, and back-pressure
•
for half-duplex mode.
8K entry MAC address table, with auto-learning and auto-aging.
•
Status LED indicators for monitoring power, 100/1000 Mbps link and activity.
•
Internal wide-range 100 – 240 volts AC power supply.
•
065-7341G 24-Port 10/100/1000BaseT/TX Gigabit Ethernet Switch
Chapter 2: Identifying Connected Devices and their Speed
This Chapter describes the front panel and rear panel of the 065-7341G switch.
2.1 Panel
Figure 1: The Signamax 065-7341G Switch's Front Panel
The 065-7341G Switch is equipped with 24 10/100/1000 Mbps Auto-Sensing
RJ-45 ports for connection of network devices. The Switch's LEDs are located
on the front panel:
Power LED: This indicator will light up when the Switch is powered on.
Link/Act LEDs (1-24): The LEDs indicate Link/Active status. The corresponding
LED indicator will light solid green when connected to a network device. It
flashes green when data is being transmitted or received on the working
connection.
The LED (1-24) indicator panel contains the following indicators:
1000M LEDs (1-24): The connected devices' speeds can be indicated by the
corresponding LEDs on the front panel. (1000 Mbps when the "1000M" LED is
illuminated green.)
Note:
The LED's description above explains the device's working status after
initialization.
Advertisement
