Alarm; Log Out - Dahua NVR4108-P User Manual

5.11 Alarm

Click alarm function, you can see an interface is shown as Figure 5-113.
Here you can set device alarm type and alarm sound setup (Please make sure you have enabled audio
function of corresponding alarm events.).
Please refer to the following sheet for detailed information.
Type
Alarm
Type
Operation Prompt
Alarm
Sound

5.12 Log out

Figure 5-113
Parameter Function
Video loss System alarms when video loss occurs.
Motion detection System alarms when motion detection alarm
occurs.
Tampering System alarms when camera is viciously masking.
Disk full System alarms when disk is full.
Disk error System alarms when disk error occurs.
External alarm Alarm input device sends out alarm.
IPC external It refers to the on-off signal from the network
alarm camera. It can activate the NVR local activation
operation.
IPC offline alarm System can generate an alarm when the network
camera and the NVR are disconnected.
Check the box here, system can automatically pops
up an alarm icon on the Alarm button in the main
interface when there is an alarm.
Play alarm System sends out alarm sound when an alarm
sound occurs. You can specify as you wish.
Sound path Here you can specify alarm sound file.
283