Aaeon EMB-Q87A User Manual page 29

8. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled "Intruder" are shorted with a jumper cap. Remove
the jumper caps only when you intend to use the chassis intrusion detection
feature.
EMB-Q87A Chassis intrusion connector
9. Digital I/0 connector (10-pin DIO)
This connector includes 8 I/O lines (In/Out programmable). All of the Digital
I/O lines are programmable and each I/O pin can be individually programmed
to support various devices.
EMB-Q87A DIO connector
NOTE: To configure the I/O pins in BIOS, go to the Advanced tab > Dynamic
Digital IO > DIO0~7. See section 3.3.2 Dynamic Digital IO for details.
Chapter 2: Motherboard information
CHASSIS
Intrudor
Intrudor
No Intrudor
PIN1
DIO
PIN 1
2-21