Table of Contents
Advertisement
1
2
2
1
3
OPERATIONAL NOTE: When the TIMER is used in the THERMO mode, the THERMO operation will discontinue only when the
"countdown time" has expired.
LOW/BATTERY INDICATOR
WE
ON
THERMO
LOW
TEMP
TIMER
FLAME
TRANSMITTER
OPERATING SAFETY MONITORS: SYSTEMS SHUTDOWN
The remote control operates on RF (radio frequency) signals that are sent by the TRANSMITTER (remote) to the RECEIVER that
operates the appliance. It is recommended that the TRANSMITTER always be located within the 20 foot operating range, preferably in
the same room in which the appliance is located.
TU
ON
THERMO
PM
TIME
FLAME
WE
ON
THERMO
HOLD
TEMP
SET
TIMER
FLAME
The word LOW outlined by a battery on the left side of the LCD screen will
appear when battery power has dropped significantly. At this time, approximately
two weeks of battery power remains until the transmitter may experience partial
HOLD
or complete loss of functions.
SET
NOTE: A reversed battery will activate the LOW battery icon.
2.
To HOLD the new temperature at a CONSTANT setting,
push the UP and DOWN buttons TOGETHER to activate
the HOLD function.
The word HOLD will appear over the SET frame and the
word OVERRIDE will disappear.
3.
To cancel OVERRIDE or HOLD, press the SET button.
TIME OF DAY DISPLAY
1
To check the current TIME of day, press the TIMER/TIME
button on the transmitter for less than 1 second. The
current TIME of day will appear in the TIME/TEMP frame
replacing the temperature reading.
2
The TEMPERATURE will reappear in 15 seconds, or you
can press the SET button to cancel the display of the time.
SETTING THE COUNTDOWN TIMER
This remote control can operate with a built-in, countdown
timer when the transmitter is in the ON or THERMO mode
(THERMO or ON must be displayed on the LCD screen). DO
NOT operate in PROGRAM MODE, as times are pre-
programmed into the transmitter.
1
Press the TIMER/TIME button on the transmitter for more
than 2 seconds. The word TIMER and 0:15 flash on the
LCD screen.
2
Press the UP or DOWN button on the transmitter to begin
advancing through each of the countdown time options.
Available countdown times are 15 min., 30 min, 45 min, 1
hr, 1 hr 30 min, 2 hr, 2 hr 30 min, and each additional half
hour up to nine hours.
3
To set the TIMER press the SET button on the transmitter.
If the system is ON, it will remain on until the "timer" has
expired. If the system is in the THERMO mode, it will
cancel ON and OFF, as the room temperature requires
until the "timer time" has expired.
4
To cancel the TIMER operation, press the TIME/RTIME
button for more than 2 seconds.
REV 8/21/06 Page 7 of 16
Advertisement
Table of Contents
