Table of Contents
Advertisement
PROGRAM
FOR
2
1,3
START
AT
4
PROGRAM
FOR
5
START
AT
6
PROGRAM
7
PROGRAM
11
START
SU
MORN
AM
SET
TIME
SU
MORN
AM
TIME
SET
SU
FOR
MORN
START
AM
AT
TIME
SET
SU
FOR
DAY
AM
AT
TIME
SET
NOTE: If the above settings were not previously completed during
the initial SET-UP and PROGRAMMING procedure, then the LCD
screen will display SU, MORN, TIME and SET temperature digits.
You must go back and perform the initial set-up procedure or the
remote will not operate properly in the PROGRAM mode. SEE
PAGE 2.
2
To program the DAY and PERIOD OF DAY, press the AHEAD or
BACK buttons to display the DAY and PERIOD you wish to
program.
3
When the DAY and PERIOD being programmed displays, then
press the PROG button and the TIME will flash on the LCD screen.
4
To program the START TIME, press the UP or DOWN button.
Programmed start time settings are in 15-minute segments. The
new set time will display on the LCD screen.
5
When the desired START TIME displays press the PROG button
and the SET TEMPERATURE will flash on the LCD screen.
6
To program the SET TEMPERATURE, press the UP or DOWN
button.
7
When the desired SET TEMPERATURE displays, then press the
PROG button.
8
After pressing the PROG button in step 7, the next PERIOD of the
same or next day will display on the LCD screen.
9
To program the next PERIOD follow steps 3, 4, 5, 6 and 7.
10 Continue to follow steps 3, 4, 5, 6 and 7 until all 7 days and the 4
time periods in each day are programmed.
11 Once ALL the programming has been completed, then press the
SET button. The programming data that has been entered will now
over-ride the factory built-in program and operate your remote
control system.
PROGRAMMING NOTE:
Once in the programming process and you want to advance
the programming procedure, you may bypass some of the
DAYS or PERIODS OF DAY, by pushing the AHEAD or BACK
buttons. This allows you to eliminate the need to enter the
TIME and TEMPERATURE for each DAY/PERIOD speeding
up the programming process by skipping some of the "software
prompts". Once the LCD screen displays a DAY/PERIOD you
want to reprogram, press the PROG button and follow the
programming steps outlined above.
REV 8/21/06 Page 4 of 16
Advertisement
Table of Contents
