Table of Contents
Advertisement
6.
Due to handling and shipping of the unit, handling or dropping of the transmitter by the customer, and heat conditions to the
receiver, some units may need an occasional frequency adjustment. This adjustment is made to improve the communication and
operating distance between the transmitter and the receiver. See RECEIVER ADJUSTMENT.
RECEIVER ADJUSTMENT – RECOMMENDED ADJUSTMENT
NOTE: The Slide Button, Gray or Black, covers the ADJ access hole when installed.
A.
To adjust at the receiver, use a small slotted screwdriver. Turn the adjustment screw counter-clockwise
about 5 degrees, and 1/8 turn. This should correct the distance problem.
B.
If that does not correct the problem, return adjustment screw to original position and then turn adjustment
screw 5 degrees clockwise.
This adjustment is like tuning your radio. If you keep turning the adjustment screw, in either direction, you will
go past the proper setting (tuning).
SPECIFICATIONS
BATTERIES: Transmitter 3.0V- 2 ea. AAA 1.5V, Alkaline
Remote Receiver 6V –4ea. AA 1.5 Alkaline
Operating Frequency: 303.8MHZ
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY
UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT.
Canadian IC ID No.'s: transmitter – 2439A-3003; receiver – 2439A-3301RX
FCC REQUIREMENTS
FOR TECHNICAL
SERVICE, CALL:
MANUFACTURED EXCLUSIVELY FOR FIREGEAR
FCC ID No.'s: transmitter –K9L3003; receiver – K9L3301RX
U.S. INQUIRIES
(888) 220-4333
Website: firegearusa.com
REV 8/21/06 Page 13 of 16
Advertisement
Table of Contents
