Table of Contents
Advertisement
13. HOLD – Displays when "programmed" SET temperature is overridden and will hold that temperature until cancelled.
14. CP – Displays when CHILD PROOF "LOCK OUT" is engaged. Pressing the UP and TIMER buttons together, engages CP.
15. SWING- Displays in SET frame when setting TEMPERATURE DIFFERNTIAL.
FUNCTIONS
To operate the system, press the MODE button on the transmitter to select the operational MODE
desired.
•
ON indicates the system is on, either manually, timed, thermostatically, or program
•
THERMO indicates the system will automatically cycle ON/OFF, depending on programmed
set temperature.
•
OFF indicates the entire system is turned off.
PROGRAM indicates the system will automatically cycle ON/OFF in the programmed mode
•
depending on the 7 day/4 period program that is in memory.
BUTTON SETTINGS
Button Settings
Setting Button
2
3
Flip open the plastic cover on the front of the transmitter to expose the "SET" buttons. The flip
cover protects the SET buttons from being changed accidentally. Close the cover after completing
the following settings/ programming.
Flashing numbers on the display indicate the system is awaiting user input, such as using the UP
and DOWN buttons to program a new setting. If no change is made to flashing digits within 15
seconds, the system will complete the procedure last programmed and reset the display to its
normal state.
INITIAL SET-UP PROGRAMMING OF TRANSMITTER
Follow the procedures below, upon FIRST USE of transmitter, setting the following program
options:
•
TEMPERATURE SETTING –
•
CURRENT DAY OF WEEK – SU, MO, TU, WE, TH, FR, SA
•
CURRENT TIME OF DAY –Hours and minutes
To program settings, first remove the battery cover on the back of the transmitter. If you have not
already installed the 2-AAA batteries, this would be a good time to do so. Note the small push
button at the upper left side of the battery compartment. This is the button used to perform the
initial transmitter programming. You will need to use a paper clip or sharp end of a pencil to
depress this button.
1.
SU
2.
AM
3.
TIME
0
F (Fahrenheit) or
CHANGING THE TEMPERATURE SCALE
Press setting button on back of transmitter ONCE and the 0F symbol
will begin flashing on the LCD screen. You may replace the battery
cover at this time.
0
0
To change
F to
C, press the UP or DOWN button on the front of the
transmitter.
After setting/confirming the preferred temperature SCALE, press the
SET button on the front of the transmitter.
NOTE: You will need to press the SET button, confirming
want the temperature readings to be in
SU
O N O F F T H E R M O P R O G R A M
0
C (Celsius)
0
F.
REV 8/21/06 Page 2 of 16
TEMP
0
F, if you
Advertisement
Table of Contents
