Table of Contents
Advertisement
3
2
2
3
PROGRAM OPERATION OF REMOTE CONTROL
PROGRAMMING DAYS/PERIOD OF DAY/SET TEMPERATURES
The user may change the built-in time and temperature programs to suit their personal schedule. Each day is divided into four
periods: MORNING, DAY, EVENING, AND NIGHT. A blank programming chart is provided to the left to record your customized time
and temperature settings.
If desired, you may change a single day or all seven days that have the built-in factory program. To change one or all seven
days, complete the following steps:
PERIOD
EVE
DAY
MORN
DAY
SU
MO
TU
WE
TH
FR
SAT
SU
AM
TIME
1.
SU
2.
3.
AM
TIME
4.
5.
The transmitter has a factory program built in. Each day has been broken into four periods
and each period has its own starting time and temperature. A chart of the built- in
programs is at the left.
You may change any of the factory settings by following the procedures below. Should you
wish to return to the factory program, follow the procedures under heading PROGRAM
REVIEW or PROGRAM CANCELLATION depending on which process you select.
PROGRAMMING THE TRANSMITTER
NITE
TIME/TEMP
SETTING THE CURRENT DAY OF THE WEEK
Following Step 3 above, the symbol SU will begin flashing on the LCD
screen.
1
To change to the current day of the week Press the AHEAD or
BACK button on the front of the transmitter.
2
After setting/confirming the current Day of the week, press the SET
button on the front of the transmitter.
NOTE: You will need to press the SET button, confirming SU, if that is
the current day.
SETTING THE CURRENT HOUR AND MINUTES
Following Step 3 on the previous page, the HOUR digits will begin flashing in
the TIME frame on the LCD screen.
To set the current HOUR, press the UP or DOWN button setting the HOUR
for the corresponding AM/PM time period.
After setting the current HOUR, press the SET button on the front of the
transmitter, and the MINUTE digits will begin flashing on the LCD screen.
To set the current MINUTES, press the UP or DOWN button setting to the
correct MINUTES.
After setting the HOURS and MINUTES, press the SET button on the front
of the transmitter.
The initial set-up/programming of the transmitter is now complete. Be sure
the slide-on battery cover is reinstalled and proceed to the next step. The
LCD screen will now display in its normal state.
BUILT –IN PROGRAM
1
Press the PROG button for 4 seconds. The shaded boxes on the
LCD screen with the words PROGRAM FOR and START AT will
begin to flash. The current DAY, PERIOD, TIME and SET
temperature of the BUILT-IN FACTORY PROGRAM will also be
displayed.
REV 8/21/06 Page 3 of 16
Advertisement
Table of Contents
