Table of Contents
Advertisement
FOR FIREGEAR FGP-305 PROGRAMMABLE TRANSMITTER
This guide is a "short cut" method to PROGRAM the operation of the programmable transmitter. For
detailed instructions for each feature and function, see OWNER"S MANUAL.
PROGRAMMING DAILY OPERATION
NOTE: A FACTORY PROGRAM is already installed in the
transmitter's software.
You may change the daily "SET TIMES" and "SET
TEMPERATURES" by following the instructions below.
9
1
2
SU
PROGRAM
FOR
MORN
1
START
AM
AT
TIME
4
NOTE: Push AHEAD or BACK buttons to advance day and period should you not want to
change each SET time or SET temperature.
QUICK PROGRAMMABLE GUIDE
SHORT CUT PROGRAMMING
1. Press PROG button for more than 4 seconds. The PROGRAM
FOR an START AT boxes on the LCD will begin blinking.
2. Program DAY OF WEEK and PERIOD OF DAY by pressing
AHEAD and BACK buttons.
3. Again, press PROG button. START TIME will begin flashing.
4. Program START TIME by pressing UP or DOWN button.
5. Again, press PROG button. SET TIME will begin to flash.
6. Program SET TEMP by pressing UP or DOWN button.
7. Again, press PROG button. The next PERIOD and DAY will
begin to flash.
8. Repeat steps 2 through 7 for all 7 DAYS until each PERIOD OF
DAY is programmed.
9. When all programmed settings are complete, then press the
SET to lock in new programming.
10. To REVIEW, either FACTORY or USER programs, push the
PROG button for ONE SECOND; then scroll through each DAY
SET
and PERIOD OF DAY by pressing PROG button, allowing ONE
SECOND between each press of this button. Press the SET
button when through reviewing the programmed times and
6
temperatures.
11. To CANCEL user-customized programming, press and hold
PROG and SET buttons together, for 10 seconds; all USER
programs will be cancelled and the FACTORY program will
return
DAY
PERIOD
MORN
All 7 Days
Factory-
DAY
EVE
Programmed
NIGHT
REV 8/21/06 Page 16 of 16
TIME/TEMP
6:00 AM 70
8:30 AM 60
3:00 PM 70
11:00 PM 63
Advertisement
Table of Contents
