Master & Slave Keyboard Setting - Honeywell ScanDome ll HTX-3000 Instruction Manual

2.4 Master & Slave Keyboard setting
You can use two keyboards at distant site.
Master keyboard should be setup as following procedure.
1. Check for dip switch the 7
2. P
ress Ctrl + Menu. Check Slave KBD setting "ON". (Network
Slave keyboard need to setup as following procedure.
1. Check for dip switch the 7
2. If you setup all connection correctly (See Figure 4) and turn on slave keyboard, you can see
following screen.
SCANDOME II Vxxx
Slave ID = 1
Input Password : xxxx
CAM : 000
3. P
ress Ctrl + Menu. Set the Slave ID to 01
4. Set Slave Node to "B" in case that master keyboard model is HTX-3000 and to "B" in case HTX-2000
Slave ID = 1
Slave Node : A / B
th
of S2 "OFF".
th
of S2 "ON".
← Current Device ID = 1
← Default setting is 9999 for administrator, 1111 for user
← 000 means that the controller is not connected to the master keyboard
← A : HTX-3000 , B : HTX-2000
15
▶ ▶
Set Slave Kbd Slave kbd:ON/OFF)