Keyboard Setup - Honeywell ScanDome ll HTX-3000 Instruction Manual

DOME
Termination
1
ON ON
OFF OFF

2.3 Keyboard Setup

User need to setup network, passwords and special functions such as Uploading and Downloading
programmed data from the dome cameras. To enter the Keyboard menu, press Ctrl + Menu. You will see
the following menu. Joystick Up/Down scrolls menu items, push the stick to Right to enter the sub-menu.
Configuration
Network
Data Bank
Alarm
Exit
Configuration
- Key Beep
- Key-Lock
- Chg User Pin -
CurrentPin : Enter 4 digits of current user's password.
NewPin
ConfirmPin :
- Chg Admin Pin -
CurrentPin : Enter 4 digits of new password.
NewPin
ConfirmPin :
Note) Factory default Administrator's password is 9999+Enter and user password is 1111+Enter.
If you forgot your own password, contact service personnel or distributor.
- Rescan Domes
-
Save and Exit
Network
Sub-
Multi-
controll
plexer
er
2 3
ON ON
OFF OFF
Table 1 – S2 Switch Setting
: ON - enable key beep sound,
OFF - Disable beep sound.
: OFF~60Min - After elapsed setup time, keyboard lock automatically.
OFF - Disable Auto Key-Lock function.
User needs login password to operate Keyboard again.
Change 4digit of user password.
: Enter 4 digits of new password.
Confirm 4 digits of new password.
Change 4 digits of administrator's password.
: Enter 4 digits of new password.
Confirm 4 digits of new password.
Scan newly installed dome cameras without turn off the Keyboard power.
Save the programmed data and return to the previous Menu
(Exit without saving if you press ESC key)
Setup properties of devices to be connected.
Controller
4 5 6
SLAVE
reserved
MASTER
13
7 8
ON
Factory
Use
OFF