Honeywell ScanDome ll HTX-3000 Instruction Manual page 14

- Set Baud rate
Dome : 2400~230K
MUX : 2400~230K
DVR485 : 2400~230K
DVR232 : 2400~230K
Save and Exit
-
Com Ports
Dome : None/Dome ...
MUX : None/DUPLEX/TRIPLEX/AUX IN/AUX I/O...
DVR485 : None/ADR/SDR/IDR/AUX IN/AUX I/O...
DVR232 : None/ADR/SDR/IDR/AUX IN/AUX I/O...
Save and Exit
Note) AUX IN : auxiliary signal input ( simplex mode)
AUX I/O : when auxiliary signal input , respond to the signal (Half duplex mode)
-
Set Slave kbd
Slave kbd : ON/OFF
MUX control : ON/OFF
Dome Menu: ON/OFF
Release :INF/001~200s
Save and Exit
- Exit
- Data Bank - Up/Download saved data of the dome
DataBank 1 : 001
Upload
Clear Data
DataBank 2 : Empty
DownLoad
Exit
- Alarm
- Alarm Check : ON/OFF
- Alarm Beep : ON/OFF
- Exit
Correspond with dome setting (9600bps)
Select the device to be connected on selected port.
Save the programmed data and return to the previous Menu
(Exit without saving if you press ESC key)
ON- Slave KBD exit, OFF- Not exist.
Set accessibility of the multiplexer menu at slave keyboard
Set accessibility of the dome camera menu at slave keyboard
INF (Infinite) - Slave Keyboard user never have the control right of the
dome which is selected by master Keyboard users
1 ~ 200s( Second) - After elapse of programmed time since master
Keyboard user use the dome, slave Keyboard user can get the control
right of the dome.
Save the programmed data and return to the previous Menu
001— Data from Dome ID 001 is exist on Bank 1
If you are sure to upload or clear data to the selected dome then
press Enter key, ESC key to cancel and exit.
If you are sure to download data from the selected dome then
Press Enter key, ESC key to cancel and exit.
Whether K/B check the alarm input of domes or not.
On : 32 domes, Off : 64 dome cameras supported.
When dome's alarm, beep sound on or off
14