Smart Control Panel Messages - Craftsman 139.18405D Owner's Manual

Smart Control Panel ®
The following messages are contained within the Smart Control Panel
Message
SAFETY SENSORS CHECK
ALIGNMENT, BLOCKAGE OR
MISWIRING SEE OWNER'S
MANUAL
Message
SAFETY SENSORS MALFUNCTION
CHECK MISWIRING SEE OWNER'S
MANUAL
Message
LEARN REMOTE CONTROL PRESS
LEARN BUTTON TO CONFIRM
Message
LEARN MODE PRESS REMOTE
CONTROL BUTTON TO PROGRAM
REMOTE
Message
LOCK MODE REMOTE CONTROL
LOCKED OUT PRESS LOCK
BUTTON TO ENABLE REMOTE
Message
ENGLISH, FRANÇAIS AND
ESPAÑOL
Message
MOTION SENSING ON MOTION
SENSING OFF
Message
BATTERY BACKUP ENABLED
Message
BATTERY BACKUP ENABLED
Message
BATTERY LOW BATTERY BACKUP
ENABLED
Message
BATTERY BAD REPLACE BATTERY
NOW SEE OWNER'S MANUAL
Message
POWER RESTORED BATTERY
CHARGING
Messages
Meaning: This message will appear if the Safety Reversing Sensors are out of alignment, if
they are blocked or if the wiring is disconnected. To clear message from door control do the
following:
• Check to see that area is clear between the Safety Reversing Sensors.
• Check to see that the Safety Reversing Sensors are not misaligned.
• Realign receiving eye sensor, clean lens and secure brackets.
• Verify door track is fi rmly secured to wall and does not move.
• Check to see that the Safety Reversing Sensors' wires are connected to the motor unit.
• If message has not cleared after the above checks, refer to message #2.
Meaning: This message will appear if the Safety Reversing Sensors are miswired. To clear
the message, do the following:
• Inspect the safety reversing sensor wires for a short (staple in wire), correct wiring polarity
(black/white wires reversed), replace/attach as needed.
• Disconnect all wires from back of motor unit.
• Remove safety reversing sensors from brackets and shorten sensor wires to 1-2 ft.
(30-60 cm) from back of each sensor.
• Reattach sending eye to motor unit using shortened wires. If sending eye indicator light
glows steadily, attach the receiving eye.
• Align sensors, if the indicator lights glow replace the wires for the sensors. If the sensor
indicator lights do not light, replace the safety reversing sensors.
Meaning: This message will appear when the 'LEARN' button has been pressed on the door
control. Pressing the 'LEARN' button again will allow the user to program an additional
remote control to the opener.
Meaning: This message will appear when the 'learn' button has been pressed a second
time on the door control or anytime on the opener. The opener is ready to program
another remote control by simply pressing the remote control button. Once the opener has
'LEARNED' the remote control, the worklight will blink one time.
Meaning: This message will appear when the 'Lock' button has been pressed and held for
more than one second. This feature will disable the opener from receiving remote control
signals. To exit 'LOCK' mode, press and hold the button for more than one second.
Meaning: This message will appear when the 'Language' button has been pressed. Pressing
the button will toggle to the next language.
Meaning: This message will appear when the Motion Sensing button is pressed. The motion
detector will toggle on or off with each press of the button.
Meaning: Opener is running on battery power.
Meaning: Opener is running on battery power with full charge.
Meaning: Opener is running on battery power with low charge.
Meaning: Battery is beyond a recoverable condition.
Meaning: Battery charging from recent battery backup state.
® and may appear during the operations of the unit:
36