Precautions In Disassembly And Reassembly Of Battery Charger - Hitachi DS 14DAL Technical Data And Service Manual

(10) Reassembly of the Hook Ass'y (W/Light) [44]
Check that the V-Lock Nut M5 [46] is mounted to the Hook Ass'y (W/Light) [44]. Mount the Hook Spring [48]
and secure it with the Special Screw M5 [49]. Make sure to mount the Hook Spring [48] with its larger
diameter side pointing inward the housing.
(11) Other precautions in reassembling
After completion of reassembly, check that the rotating direction of the Drill Chuck [2] matches the position of
the Pushing Button [41]. When the Pushing Button [41] is pressed from the (R) side, the rotating direction of
the Drill Chuck [2] should be clockwise as viewed from behind. Check that the runout of the Drill Chuck [2] is
0.8 mm or less at the position 110 mm away from the tip of the chuck using a 12-mm dia. test bar.
(12) Screw tightening torque
Special Screw (Left Hand) M6 x 23 [1]
Drill Chuck [2]
Screw Set D3 x 12 [19]
Brush Cap [34]
Tapping Screw (W/Flange) D3 x 16 (Black) [35]
Machine Screw (W/Sp. Washer) M3 x 4 [39]
Special Screw M5 [49]

10-2. Precautions in Disassembly and Reassembly of Battery Charger

Please refer to the Technical Data and Service Manual for precautions in disassembly and reassembly of the
Battery Charger UC 18YRL.
: 3.92 --- 4.9 N m (40 --- 50 kgf
•
: 17.6 --- 21.6 N m (180 --- 220 kgf
•
: 0.62 --- 0.94 N m (6 --- 10 kgf
•
: 0.68 --- 0.88 N m (7 --- 9 kgf
•
: 1.0 --- 1.6 N m (10 --- 16 kgf
•
: 0.29 --- 0.39 N m (3 --- 4 kgf
•
: 1.47 --- 2.45 N m (15 --- 25 kgf
•
--- 21 ---
cm)
•
cm)
•
cm)
•
cm)
•
cm)
•
cm)
•
cm)
•