Vacuum Unit Supreme 150 / Performer 150 / Supreme 250 / Performer 250 / Supreme Lcd Assembly Instructions; Fitting The Wall Bracket; Locating The Vacuum Cleaner On The Wall Bracket; Connecting The Machine - Nilfisk-Advance Supreme 100 Instructions For Use Manual

5 Vacuum unit Supreme 150 / Performer 150 / Supreme 250 / Performer 250 /
Supreme LCD assembly instructions
Fig. 15
Fig. 16
Fig. 17
Exhaust

5.1 Fitting the wall bracket

Plan the positioning of the wall bracket so that there is plenty
of space above and below the area where the vacuum unit is
to be located. Make sure there is a minimum of 200 mm free
space below the dust container.
Mark the positions for all four screw holes with a pen or simi-
lar. The diameter of the holes in the holder is 5 mm. Select
screws and, if necessary, wall plugs suitable for the type of
wall concerned. Drill the four screw holes.
Fit the wall bracket with the large opening pointing down-
wards, see Fig. 15. Then screw the holder fi rmly into place.
5.2 Locating the vacuum cleaner on
To facilitate the procedure, fi rst remove the dust container.
Free the container by pulling both handles outwards. Then
remove the container from the machine. To mount the vacuum
cleaner/motor chassis to the wall bracket - just lower the chassis
downwards so that the locking device of the bracket will pass
through the slot of the chassis Fig. 16. Make sure the corre-
sponding bracket on the machine is held fi rmly in place by
the wall bracket.
When removing the motor chassis from the wall bracket - push
the locking device towards you so it will release the chassis and
then lift the chassis up from bracket.

5.3 Connecting the machine

T
the lower position and the exhaust pipe uppermost, Fig 17.
The fl exible hose is connected to the dust inlet at the con-
tainer of the cleaner. Push the hose in to the inlet at the cleaner
until the hose locks. Press the button on the hose inlet down-
wards in order to remove the suction hose. The fl exible suction
hose acts as an adapter connecting the vacuum unit with the
pipe system.
NB! These connections must not be glued in case the
unit is handed in for service.
Position the central vacuum cleaner so that the exhaust pipe
can be kept as short as possible, maximum. 5 metres. Take
the surroundings into consideration when positioning the
exhaust. For this reason, you should always fi t a muffl er.
For additional information concerning the assembly and
installation of the pipe system and low-current lead, please
refer to the separate assembly instructions supplied with the
pipe package.
Push the hose in to the inlet at the cleaner until the hose locks.
Press the button on the hose inlet downwards in order to remove
the suction hose.
Inlet
the wall bracket
he machine is connected with the fl exible suction hose in
41