Electrical Connection - Nilfisk-Advance Supreme 100 Instructions For Use Manual

8 Electrical connection

On/Off
The control current outlet (low voltage) is connected to a control
current lead running the length of the pipes. Both ends of the
low-voltage lead are connected to the connection panel on the
vacuum unit. One lead to each outlet. The low-voltage lead
should be connected as informed below.
Location of the outlet for the low-voltage cables:
Supreme 100
Supreme 100
The connection panel is
located in the bottom of
the vacuum unit.
Connection of the low voltage cables
The low voltage cables that runs along the pipes, is to be con-
nected to the connector at the vacuum cleaner. Connect the
ends of cables in the electrical sockets, one cable end in each
socket. Secure the low voltage cables by pulling the snap lock-
ings at the connector, downwards.
Secure the low voltage
cables at the connector
- pull the snap lockings
at the connector
downwards.
Low voltage cable
Supreme 150 /
Performer 150 /
Supreme 250 /
Performer 250 /
Supreme LCD
The connection panel is
located in the top of the
vacuum unit
Connector
Connection panel
All models have the low voltage cable connector placed to the
left on the panel. These models do also have two extra outlets
on the panel. These outlets are prepared for future functions and
are not in use for the moment. The connector for the cable to the
transceiver box is placed to the right.
45